DIY Hand Harness

Here is a little DIY tutorial on how to make the pearl and silver hand harness I am wearing in this post.

Supplies;

Silver Chain

Pearl Chain

2 Jump Rings

Wire Cutters

Pliers

Step One-

Use pliers to attach a jump ring to the end of the chain.

Step Two- Measure the chain around your finger (I prefer middle, but whatever works!), and secure with jump ring.

Step Three- Cut a little of the way down (about right where your knuckles end) with the wire cutters.

Step four- repeat step one, and measure around your wrist (loosely so it can slip on and off, but tight enough so it stays on) and secure the jump ring.

Step Five- Cut a little of the ways up with the wire cutters.

Step Six- Use the pliers to open up the top of the pearl chain, connect it to the end of the chain for your finger, close it with the pliers.

Step Seven- cut the pearl chain with the wire cutters so that it reaches the top of the chain for the wrist.

Step Eight-repeat step six so the pearl chain is connecting the wrist and finger chains

Your new hand harness!

xoxo